hudson torque chart

Unknown
Unknown
edited November -1 in HUDSON
is there a torque chart in the archives for hudsons ? am looking for the tightening settings for the 6 flywheel nuts and the clutch to the flywheel thanks - gh

Comments

  • hudsontech
    hudsontech Senior Contributor
    There are torque specs in the Hudson Service Merchandisers:



    1950 - Vol 1, No. 1 - Page 58

    1952 - Vol 4, No. 3 - Page 286

    1953 - Vol 5 - Hydramatic Transmission



    Since I'm not sure if you have the correct terminology I'm not sure if this is what you are looking for.



    There are none shown in the 1951 and 1954 issues. I have a set of Service Merchandisers. 1949 thru 1954, on CD. I can send you the pages of whichever you need - the whole magazine of each year runs around 108 MB, a bit large to email - if you have a 51 or 54, at least other years would give you an idea of what the torque value is.



    These torques should be in the various service manuals.



    Hudsonly,

    Alex Burr

    HudsonTech

    Memphis, TN
  • [Deleted User]
    [Deleted User]
    gustavoh wrote:
    is there a torque chart in the archives for hudsons ? am looking for the tightening settings for the 6 flywheel nuts and the clutch to the flywheel thanks - gh
    The flywheel is torqued at 40 to 45 ft lbs. The cover is torqued to20 to 25 ft lbs. This is in the Hudson Procedure Manual 1952 models, 7-8 and page 7-9. Walt.
  • Unknown
    Unknown
    thank you for the info on those footpounds and other onfo about the hudson literature - gh
This discussion has been closed.

Categories

In this Discussion