Desperately Seeking Clutch Alignment tool

DocHornet · September 2011

I'm ready to install my manual tranny with rebuilt clutch from Ron Fellows. Can't seem to find a source for a clutch alignment tool.

Does anyone have one they would sell or lend?

Phil@Auldridge.org 512 517-0055

Richard E. · September 2011

Where are you located? Don't you have an old transmision laying around that you could pull the front shaft out of?

ski4life65 · September 2011

http://21stcenturyhudson.net/products2.htm

They are only $12.50 from Randy and Russ

DocHornet · September 2011

Thanks for that connection. Once I saw that the "store-bought" units don't have a splined shaft, I just measured the input shaft diameter and turned my own on the lathe

Desperately Seeking Clutch Alignment tool

Comments

Categories

In this Discussion