Installing Trim on \'47

Unknown
Unknown
edited November -1 in HUDSON
Hi all. I was wondering what was the best way to safely install trim on my Hudson without scratching up my fresh pain and getting it all right in one try?
Any ideas are welcome. There's lots of stainless on this car.
ad19789@hotmail.com

Comments

  • PAULARGETYPE
    PAULARGETYPE Senior Contributor
    well 1st off take your time we always grease our chrome before we install it it goes over the retainers easyer and we use 2 guys 1 to hold the stainless and one to get the retainer just where you want it we then screw it in place and do the dry run with both guys 1 tightening up the screws and having 1 on each end and striking down on the stainless so it goes on easy good luck cool.gifcool.gifcool.gifcool.gifcool.gifcool.gifcool.gifcool.gif
This discussion has been closed.

Categories

In this Discussion