Stepdown Shift Linkage bushings needed

[Deleted User]
[Deleted User]
edited November -1 in HUDSON
Hi to all



The shift rods on my 53 Wasp are great... but the bushings in the shift linkage are not the best. I am looking for NOS or a replacement part that will allow me to properly adjust the linkage... any suggestions?



Help.....



The part I need is 306423 and I need two of those rascals.... see the following picture...



HudsonShiftlinkage.jpg



Thanks

Comments

  • Unknown
    Unknown
    i gave a nos one to DANY SPRING OF K GAP AND PRODDED HIM TO HAVE THEM MADE, AS I GET A LOT OF REQUESTS FOR THESE, CHECK WITH HIN AND SEE HOW SOON HE WILL HAVE THEM, BILL ALBRIGHT
  • [Deleted User]
    [Deleted User]
    Thanks Bill
  • TOM-WA-
    TOM-WA- Senior Contributor
    You can also try Doug Wildrick.. I think I recently got a set from him
  • [Deleted User]
    [Deleted User]
    I'm going to be needing some of these at some point as well. Whomever has them, or will have them, is good information.



    Are these the same bushings as the single lever too?



    Mark
  • Unknown
    Unknown
    yes, and double lever too, bill albright
This discussion has been closed.

Categories

In this Discussion