Portland Swap Meet

drivergo2
drivergo2 Expert Adviser
edited November -1 in HUDSON
Anyone going to the portland swap meet April 3rd 4th and 5th. I havent been in years but i need some small parts for my 52 Hornet. Thanks John drivergo2:)

Comments

  • hornet53
    hornet53 Senior Contributor
    I'll be there! Just happen to be in town that weekend. According to the Northwest Chapter newsletter, there will be a 3/4 acre Hudson stall at the swap meet down at the racetrack and a few stalls in building A at the Expo Center. They are seperate entities and you'll have to pay two admissions to see it all.

    Jim Harmon and Dick Riggs will be down at the racetrack, and NW Chapter Pres Daphne Smith will be up at the Expo.

    Don't forget, NW Chapter Banquet Sat night at the Beaterville Cafe, call Jan at 503-281-7459 for necessary reservations.
  • MikeWA
    MikeWA Senior Contributor
    drivergo2 wrote:
    Anyone going to the portland swap meet April 3rd 4th and 5th. I havent been in years but i need some small parts for my 52 Hornet. Thanks John drivergo2:)



    You might want to call Jim Harmon beforehand, and he could bring your parts to the meet. I don't know what you need, but I'll bet he has it. I don't have his number handy, but its in the directory.
  • Mike (WA) wrote:
    You might want to call Jim Harmon beforehand, and he could bring your parts to the meet. I don't know what you need, but I'll bet he has it. I don't have his number handy, but its in the directory.
    I have been to Jim Harmon's a number of times and I swear that you could build a Hudson from scratch with the stuff he has on hand. His cell phone is 503-804-6399. Good luck.



    Doug
  • hornet53
    hornet53 Senior Contributor
    dougc_portland wrote:
    I have been to Jim Harmon's a number of times and I swear that you could build a Hudson from scratch with the stuff he has on hand. His cell phone is 503-804-6399. Good luck.



    Doug



    "A Hudson"??????? Are you kidding? You could build several, of several different eras.
This discussion has been closed.