Jet valve size ???

Unknown
Unknown
edited November -1 in HUDSON
6 exhaust valves-- These were supposed to fit my 212 but they don't , too short .-- Head size 1 3/8-- - stem dia 3/8---stem length 5 3/16----Anyone know if they might be for a 202 Jet motor ? BUD

Comments

  • Geoff
    Geoff Senior Contributor
    No, they won't fit the Jet, but are for the 8 cylinder '36-'37 models.

    Geoff.
  • Unknown
    Unknown
    Geoff C., N.Z. wrote:
    No, they won't fit the Jet, but are for the 8 cylinder '36-'37 models.

    Geoff.
    Geoff , my manual says the 8 cyl has a 1 1/2 inch valve head . BUD
  • Geoff
    Geoff Senior Contributor
    Obnly the inlet valves. The exhausts are 1-3/8"
  • Unknown
    Unknown
    Geoff , you're right , I should have gone to the next page where it gives another set of valve specs . Would still have left me in a puzzle as it does not say inlet or exhaust . If anyone needs these they are new and I have no use for them . Only have six of them . Thanks , BUD
This discussion has been closed.

Categories

In this Discussion