'35 kingpin ball bearings

bob ward
bob ward Senior Contributor
edited April 2013 in HUDSON
What diameter ball bearings do I need for the top of '35 kingpins?

Comments

  • russmaas
    russmaas Senior Contributor
    .026 off the top of my head
  • Geoff
    Geoff Senior Contributor
    That's really tiny! Parts book says 1/4", 10 of them required.
    Geoff
  • bob ward
    bob ward Senior Contributor
    Thanks guys. I thought probably 1/4", the end of a 1/4" drill bit fits the groove well, but its good to get official confirmation.
  • russmaas
    russmaas Senior Contributor
    i was off a decimal point, my bad
  • russmaas
    russmaas Senior Contributor
    FYI I can sell you a complete set with pins/bushings etc.
This discussion has been closed.

Categories

In this Discussion