trim retainer

RonS
RonS Senior Contributor
edited October 2013 in HUDSON
Does any one sell or reproduce the trim retainer for the 52-53 rear belt molding? Those are for the stainless trim pieces that curve around from the B pillar and go around the C pillar and meet each side at the bottom center of the rear backlight. Part #s are 231762 &231763 for the Club Coupes.

Comments

  • [Deleted User]
    [Deleted User]
    Ron, No one does a curved molding retainer if that is what you mean. I have taken long straight strips and cut them about 1" wide Then place them in the area about 2" apart where the long Hudson made curved retainers would be placed. It's a bit more work but if you have patience it will work out. Just be careful in the layout.
  • JMed
    JMed Expert Adviser
    Does anyone sell the straight strips? I will need a full set for my '52
  • RonS
    RonS Senior Contributor
    edited October 2013
    Lance please send an Email to rsotardi@yahoo.com. I never know if this forums reply goes through. I sent a message earlier. Jmed send me @ same email.
This discussion has been closed.

Categories

In this Discussion