Rear Quarter Window Glass
I am replacing the rubber seals around the rear quarter windows (pivot) on my 52 Hornet Sedan. The body manual says to: 1. Remove the three sheet metal screws attaching garnish
moulding to window opening, 2. Push glass inward and remove glass, weatherstrip and
frame. For installation, it says to reverse the removal procedure. The process seems straightforward. Anything that I should know that is left out of the manual?
I purchased the seals from WRP. Do I need to use any type of sealant when installing the seal on the frame? Also, what should I use to connect the two ends to each other?
Thanks in advance for your assistance.
I purchased the seals from WRP. Do I need to use any type of sealant when installing the seal on the frame? Also, what should I use to connect the two ends to each other?
Thanks in advance for your assistance.
0
Categories
- 36.9K All Categories
- 112 Hudson 1916 - 1929
- 20 Upcoming Events
- 92 Essex Super 6
- 28.6K HUDSON
- 571 "How To" - Skills, mechanical and other wise
- 995 Street Rods
- 151 American Motors
- 178 The Flathead Forum
- 49 Manuals, etc,.
- 78 Hudson 8
- 44 FORUM - Instructions and Tips on using the forum
- 2.8K CLASSIFIEDS
- 608 Vehicles
- 2.1K Parts & Pieces
- 77 Literature & Memorabilia
- Hudson 1916 - 1929 Yahoo Groups Archived Photos