Trunk/Cabin separator behind rear seat.

GrimGreaser
GrimGreaser Senior Contributor
in HUDSON
Hi guys, 
Just got my seats back from the upholsterer and am working on getting the rear seat area ready.  How was the trunk divider installed? I see recesses for it on the sides of the opening, but I dont see any other retaining features. Did it share mounting holes with the center armrest assembly?  Just figured I'd ask real quick before doing a detail search.

Oh, by the way here's the front:

Comments

  • Lance
    Lance Member
    It's basically a large piece of flexible paperboard that was covering over the open space. Nothing very elaborate. A few sheetmetal screws and some speed nuts ought to secure it. Coupes, broughams and sedans all used pretty much the same setup. A convertible was the only model that had a sheetmetal bulkhead. It dosen't secure with anything else
  • GrimGreaser
    GrimGreaser Senior Contributor
    Thanks Lance, I knew it wasn't much. But i didn't see any spare screw holes.

  • Kdancy
    Kdancy Senior Contributor
    Seat looks really nice! Their is an ABS plastic board a lot of people are using in place of cardboard.
    You won't know the difference in that area and it won't rot.
  • Kdancy
    Kdancy Senior Contributor
    Who did the seats?
  • GrimGreaser
    GrimGreaser Senior Contributor
    Local Colorado shop. http://www.airupholstery.com
  • Kdancy
    Kdancy Senior Contributor
    What is the electrical connector under the seat for?
  • GrimGreaser
    GrimGreaser Senior Contributor
    I had seat heaters put in.

Categories

In this Discussion