Intake manifold

5433HET

I'm ready to install the intake manifold to the block,(with new gasket)on my Splasher 6. Is any type of gasket sealant recommended,or just  installed dry?

bob ward

As long as the manifold has a flat mating surface dry will do nicely.

RichardD

I would use blue Hylomar; it is the best and not cheap !!
www.amazon.com/Hylomar-172-148-Universal-Gasket-Sealant/dp/B00J4Z7N9I

BigSky

Doug Wildrick recommended to me to use the Permatex Ultra.  Very thin coating on both sides was his recommendation.  Above all else, which I’m sure you know, is a flat clean surface.