this guy has a nice new engine (with pictures!)

Comments

  • Unknown
    Unknown
    yorgatron wrote:
    http://www.jalopyjournal.com/forum/showthread.php?t=117938
    Take a look at this stuff... a NEW to me conversion





  • hornet53
    hornet53 Senior Contributor
    That's the trans for me! How hard was the conversion?
  • Unknown
    Unknown
    The best news about the adapter is that you could put a Hudson motor in your GM product of choice, right? Hey, turnabout is fair play.

    Bob
  • Unknown
    Unknown
    hornet53 wrote:
    That's the trans for me! How hard was the conversion?

    That happens to be my car. The conversion was simple. It came with the adapter plate, flywheel, and all the hardware to install it. I have only driven it a little, since the engine has only been in for about a week. Everything seems to be fine, the hydraulic throw out bearing seems to make alot of noise. I will need to look into that. Any questions about the adapter I would be glad to help, also Pat at Wilcap is very helpful.
  • Unknown
    Unknown
    The Kid wrote:
    That happens to be my car. The conversion was simple. It came with the adapter plate, flywheel, and all the hardware to install it. I have only driven it a little, since the engine has only been in for about a week. Everything seems to be fine, the hydraulic throw out bearing seems to make alot of noise. I will need to look into that. Any questions about the adapter I would be glad to help, also Pat at Wilcap is very helpful.



    What, no intro? Good to see new folks on this forum. Modified or stock, I welcome you. Good looking car and great installation, it's great to see somebody using the Hudson motor other than the ubiquitous SBC.:rolleyes:
This discussion has been closed.

Categories

In this Discussion