Removing bearings on Hudsons and Terraplanes
barrysweet52
Expert Adviser
Photo shows a simple tool I have made from thick tube. Distance between front 5/16 threaded holes is different to the holes at the back. Bearing block is a tight fit so its important to pull block out vertically - I used a caliper to check the starting clearance then wound the end bolts the same number of turns. Could have welded a nut under the tube but just used a spanner. I used a scrap piece of steel under the end bolts so that it didnt damage the crankcase. I very quick easy job. Hope its of interest and will help someone.
0
Comments
-
Clever idea, thanks for sharing.0
-
Thanks for sharing Barry.0
Categories
- 36.8K All Categories
- 98 Hudson 1916 - 1929
- 17 Upcoming Events
- 84 Essex Super 6
- 28.5K HUDSON
- 539 "How To" - Skills, mechanical and other wise
- 992 Street Rods
- 150 American Motors
- 171 The Flathead Forum
- 49 Manuals, etc,.
- 72 Hudson 8
- 43 FORUM - Instructions and Tips on using the forum
- 2.8K CLASSIFIEDS
- 597 Vehicles
- 2.1K Parts & Pieces
- 76 Literature & Memorabilia
- Hudson 1916 - 1929 Yahoo Groups Archived Photos