Re: [HSS] Clutch Tools

Unknown

Hudson29@aol.com wrote:

>

> I have been looking without success for a clutch alignment tool to fit

> the '29 Hudson clutch. My good buddy and fellow Super Six list member Big Jim

> has a wood lathe and I will be speaking to him about the possibility of

> spinning one up in wood, plastic or metal. Should he be interested, is anyone

> else interested in ordering one? If there be enough interest, it might be

> worth setting up a small production run.

>

> Paul O'Neil, Hudson29@aol.com

> Fullerton, California USA

>

> NEW email list for Hudson Super Six Cars, 1916-1929!

> http://www.egroups.com/group/HudsonSuperSix16-29

>

> 1926 Hudson Anderson Bodied Coupe

> 1926 Hudson Parts Car "The Grapes Of Wrath"

> 1928 Hudson Roadster Project

> 1929 Hudson Town Sedan

> 1939 Cadillac Coupe (How'd that get in there?)

>

> AEROMARK - Need Rubber Stamps or Signs? See:

> http://www.aeromark.net

>

> Community email addresses:

> Post message: HudsonSuperSix16-29@onelist.com

> Subscribe: HudsonSuperSix16-29-subscribe@onelist.com

> Unsubscribe: HudsonSuperSix16-29-unsubscribe@onelist.com

> List owner: HudsonSuperSix16-29-owner@onelist.com

>

> Shortcut URL to this page:

> http://www.onelist.com/community/HudsonSuperSix16-29

Sounds like a good idea Paul. I fortunately have a spare input shaft

which use as an alignment tool, but before I had this I have used the

"eye-ometer" method. Otherwise you can leave the pressure plate bolts

out and offer the whole assembly up to the flywheel, but this is VERY

heavy to do.

Geoff.