Re: [HSS] Water pump

Unknown

Just talking Water pumps and slightly off the SS trail I
have for 1913 Mobel 37 (4 pot conty motor) a set of patterns to cast a
fresh water pump. I even think I have one side spare cast as I only remember one
'prototype' when machining them.. n e one ever have a need who will no
where!

 

Martyn

UK

----- Original Message -----

From:
Jerre
Hoffman

To: HudsonSuperSix16-29@yahoogroups.com

Sent: Friday, January 18, 2002 5:45
AM

Subject: [HSS] Water pump

I have 2 shafts and impellers I made for my 16,  6-40.
They need more work but the one i used for mine is holding up. I had the
impellers cast in bronze. (No undercut, reused housing)  The shaft was
made from steel. i should have had it plated before I installed it but hey
I've got great 20-20 hind sight and I'm not ready to do it again. I don't know
if these would fit a SS. The shaft runs on right side of engine, gear driven,
water pump and into Starter/Gen/Dist thru a coupling. If you need to contact
me hofhudson@earthlink.net. Good
luck Jerre

Community
email addresses:
  Post message:
HudsonSuperSix16-29@onelist.com
  Subscribe:   
HudsonSuperSix16-29-subscribe@onelist.com
  Unsubscribe: 
HudsonSuperSix16-29-unsubscribe@onelist.com
  List owner:  
HudsonSuperSix16-29-owner@onelist.com

Shortcut URL to this
page:
  http://www.onelist.com/community/HudsonSuperSix16-29


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.