Re: [HSS] Shaft Seal for Lever Type Shock- 1929 Type R

Unknown

The firm that rebuilt my shocks manymoons ago, reamed out the worn housing,

and made up a solid neoprene block seal which compressed into the housing

and held in place by the arm. Has been effective. Sadly this firm no longer

exist, but it sould be a simple engineering procedure.

Geoff.

----- Original Message -----

From: "jjpippers" <HARPER@fhwelding.com>

To: <HudsonSuperSix16-29@yahoogroups.com>

Sent: Tuesday, December 14, 2004 7:35 AM

Subject: [HSS] Shaft Seal for Lever Type Shock- 1929 Type R









After roasting the existing seal with a torch (couldn't get it apart

any other way) I need to replace the shaft seal on my lever type

shock. This is the seal between the casting and the rotating arm.

Are they available? What were they made of? Cork?













Community email addresses:

Post message: HudsonSuperSix16-29@onelist.com

Subscribe: HudsonSuperSix16-29-subscribe@onelist.com

Unsubscribe: HudsonSuperSix16-29-unsubscribe@onelist.com

List owner: HudsonSuperSix16-29-owner@onelist.com



Shortcut URL to this page:

http://www.onelist.com/community/HudsonSuperSix16-29

Yahoo! Groups Links