Re: [HSS] A Couple Of ??

Unknown

There is a thin gasket between the adjusting flange and the crankcase, and

between the flange and the bronze housing. You need a wire to carry 30

amps. Anything less will cause heating and voltage drop. I'm not sure of

the wire gauges you use in your country. Here they are marked in amperage,

15 or 30 usually. As a rule - "If in doubt, fit a heavier wire than you

think you will need".

Geoff.

----- Original Message -----

From: "standardsedan29" <sultans@webtv.net>

To: <HudsonSuperSix16-29@yahoogroups.com>

Sent: Wednesday, August 30, 2006 2:53 PM

Subject: [HSS] A Couple Of ??





>I am getting a oil leak from around where the adjustment plate bolts to the

>motor where you can adjust the timing chain. I had this apart many years

>ago when I had the water pump/generator shaft out for repair and not sure

>if there is some type of seal in there ? Please advise. And, what size wire

>to use to replace the charging wires from the generator to amp meter to

>battery ? Thanks, Ron

>

>

>

>

>

>

> Community email addresses:

> Post message: HudsonSuperSix16-29@onelist.com

> Subscribe: HudsonSuperSix16-29-subscribe@onelist.com

> Unsubscribe: HudsonSuperSix16-29-unsubscribe@onelist.com

> List owner: HudsonSuperSix16-29-owner@onelist.com

>

> Shortcut URL to this page:

> http://www.onelist.com/community/HudsonSuperSix16-29

> Yahoo! Groups Links

>

>

>

>

>

>

>

>

> --

> No virus found in this incoming message.

> Checked by AVG Free Edition.

> Version: 7.1.405 / Virus Database: 268.11.7/432 - Release Date: 29/08/06

>

>