Re: [HSS] 27 Hudson F-Head Sizing and Securing Water Jacket Discs

Unknown

Flatten them out first, before you put them in, and see if they fit.

Otherwise get the right size. Drill a 1/4" hole in them, to allow at least

some water to circulate.

Geoff.

----- Original Message -----

From: "okgat" <okgat@hughes.net>

To: <HudsonSuperSix16-29@yahoogroups.com>

Sent: Friday, April 06, 2007 5:25 PM

Subject: [HSS] 27 Hudson F-Head Sizing and Securing Water Jacket Discs





> Hi Again,

>

> I am ready to place the head back and secure it. I have learned from

> prior messages the two open holes in the center of the block were

> formed for sand casting purposes.

>

> I have purchased disks, but I am not sure if I have purchased the

> correct size or shape. The two center holes adjacent to the pistons

> measure 1.5".

>

> The discs I have purchased are 1 3/8" curved steal discs. If I hit

> them while in place they may flatten out to the required size, but I

> feel uneasy about doing this.

>

> Questions:

>

> 1) Should I find flat disks the 1.5" in size or?

>

> 2) Should I attempt to somehow sodder the discs in place or?

>

> Thank you,

>

> Rick Gatling.

>

>

>

> Community email addresses:

> Post message: HudsonSuperSix16-29@onelist.com

> Subscribe: HudsonSuperSix16-29-subscribe@onelist.com

> Unsubscribe: HudsonSuperSix16-29-unsubscribe@onelist.com

> List owner: HudsonSuperSix16-29-owner@onelist.com

>

> Shortcut URL to this page:

> http://www.onelist.com/community/HudsonSuperSix16-29

> Yahoo! Groups Links

>

>

>

>

>

> --

> No virus found in this incoming message.

> Checked by AVG Free Edition.

> Version: 7.5.446 / Virus Database: 268.18.26/748 - Release Date: 5/04/2007

> 3:33 p.m.

>

>