(no subject)
Hello Hudson Members.
I need a little help on my 29 Hudson. My car is a early 29 and it
has 92,000 miles on it.
The cylinder walls have too much taper. It need to be
bored. They say that Land Rover pistons
bored. They say that Land Rover pistons
will be the same side bore but the wrist pins are a different
size. Could make a bushing for
size. Could make a bushing for
the smaller wrist pin.
They also tell me that a 51 to
54 Hudson will fit but you have to bore the block out
54 Hudson will fit but you have to bore the block out
to 3- 9/16 for the new Hudson piston. I would like to know if
the block has enough cylinder
the block has enough cylinder
walls for the new size?? I dont want any heating
problems.
problems.
If you member have any information on this I sure would like to know.
Thank you very much, and Happy Motoring.
Bob Hopkins Jr.
0
This discussion has been closed.
Categories
- 36.8K All Categories
- 98 Hudson 1916 - 1929
- 15 Upcoming Events
- 85 Essex Super 6
- 28.5K HUDSON
- 540 "How To" - Skills, mechanical and other wise
- 992 Street Rods
- 150 American Motors
- 171 The Flathead Forum
- 49 Manuals, etc,.
- 73 Hudson 8
- 43 FORUM - Instructions and Tips on using the forum
- 2.8K CLASSIFIEDS
- 597 Vehicles
- 2.1K Parts & Pieces
- 76 Literature & Memorabilia
- Hudson 1916 - 1929 Yahoo Groups Archived Photos