29 Super Six cam shim

Unknown

Attachments :

shim retaining pin.jpg

remnants of shim.jpg

I have a '29 Hudson Super Six F head engine in the shop for a complete rebuild and I have got down to getting everything ready to reassemble. There is supposed to be a thrust shim that sits between the camshaft flange and the block that is held in place by a 1/8" diameter pin and all I have is a one inch wide tab. I have the capabilities here to make a replacement out of brass but does anyone here maybe have a picture, scan or drawing of what the original was? I have enough stock to make it full round or just 180 degrees to only cover half. Any help will be appreciated. The pin is shown on crankcase after I had line bored the mains, the second picture is what was left when I tore the engine down.

Mike ...