35 terraplane center hood brackets

System
System Member
edited September 2021 in HUDSON
Please create new discussions if you are seeking parts rather than adding to an existing one

This discussion was created from comments split from: Center Hood Brackets.

Comments

  • JML55
    JML55 Member
    Would these be the same for a 35 terraplane, I need a set?
  • Old Fogey UK
    Old Fogey UK Expert Adviser
    JML55 said:
    Would these be the same for a 35 terraplane, I need a set?
    They don't look like the ones on my '34 which will be the same as a '35.
  • Toddh
    Toddh Member
    Old Fogey UK said:
    JML55 said:
    Would these be the same for a 35 terraplane, I need a set?
    They don't look like the ones on my '34 which will be the same as a '35.
    Agree.  Same for my 34 Terraplane 
  • JML55
    JML55 Member
    Toddh said:
    Old Fogey UK said:
    JML55 said:
    Would these be the same for a 35 terraplane, I need a set?
    They don't look like the ones on my '34 which will be the same as a '35.
    Agree.  Same for my 34 Terraplane 
    could you post pics of yours please 
  • Toddh
    Toddh Member

  • Old Fogey UK
    Old Fogey UK Expert Adviser
    Todd - your rear bracket is different from mine. Is it original?  Both of mine look like your front one.
  • Toddh
    Toddh Member
    Yes it’s original except for the screws.  
  • Old Fogey UK
    Old Fogey UK Expert Adviser
    Toddh said:
    Yes it’s original except for the screws.  
    My apologies, Todd. Once I enlarged the pic, I could see that I had been misled by reflections on it. I put mine back in place with stainless slotted head and countersunk set screws to replace the rusty originals.
    If your set up is the same as mine with identical brackets at each end, JLM55 ought to be able to use the end clamps from Vintage Car Parts because the chrome hinge strip they sell in conjunction with them has the same profile as the original Hudson hinge strip.

Categories

In this Discussion