Hudson Jet Clutch Pilot Tool

Can anyone recommend a part number for a clutch alignment tool for a jet? I need to purchase the tool for my jet and see they are different spline count than the stepdown wet clutch.

Thanks,

Rich

Comments

  • Either use a spare spline shaft, or machine a tool out of steel to the dimensions of the input shaft, that fits through the clutch plate and into the bushing in the flywheel.

  • Ratlee I would be happy to make you that tool - aluminum would work unless you plan to do 50 of them. I do need dimensions. I think just a round shaft into the splines and smaller diameter for flywheel bushing. Just pay for material and shipping. Not familiar with Jet. Gert

  • Gert,

    Thanks for the offer. Good point on the tool not needing to be splined where it goes through the clutch disc. I will be pulling the drivetrain next month and I will get the measurements.

    Rich

  • Someone here likely has those dimensions and can provide them - Gert (retired machinist)

  • Wildricks sells them. Part number PN200. $10

  • ratlee2
    edited September 17

    I believe pn200 only fits the 6 spline wet clutch discs, not the 10 spline 1 inch input on the jet.

  • Let me know if I can help - Gert

  • Bummer, like everything it's always something