Walt here; Carburetor

[Deleted User]

I have an UPDRAFT STEWARD CARBURETOR made by the DETROIT LUBRICATOR CO. MODEL 25, PAT 11-28-11 and stamped J-2580. Can anyone tell me what it fits?

Unknown

walt's garage-53 wrote:

I have an UPDRAFT STEWARD CARBURETOR made by the DETROIT LUBRICATOR CO. MODEL 25, PAT 11-28-11 and stamped J-2580. Can anyone tell me what it fits?

Might want to post this at the Yahoo Hudson 1916 1929 Super Six message board. More of the older Hudson cars and folks that own them over there.

hudsonsplasher1

walt's garage-53 wrote:

I have an UPDRAFT STEWARD CARBURETOR made by the DETROIT LUBRICATOR CO. MODEL 25, PAT 11-28-11 and stamped J-2580. Can anyone tell me what it fits?

Walt;

That is the same carb that's on my 28 Essex. It may fit earlier model also.

Gene.

Unknown

Check this out Walt.



http://www.prewarcar.com/parts/list.php?s=p&pmid=386

hudsontech

I think, according to what I can figure out, also fits 1924-1926 Hudson - if it does I know somebody can use it. Fellow in Idaho just bought a 1926, 14,500 miles, beautiful car - but doesn't have a carburetor and missing a few fuel lines.

Just dropped him an email, CC to you, to contact you.



Hudsonly,

Alex Burr

HudsonTech

Memphis, TN

35Terra

Speaking of carbs. Where does one go to get carb rebuild kits?



Jim

Unknown

Jim, what ever you find, DO NOT buy any NEW OLD STOCK, it's all junk

Geoff

It is for all Essex 6, 1924-1928 incl. The Hudson carburettor is much bigger (1-5/8" throat), and doesnt have the elbow n the upper portion.

Geoff.

coverton

I get them from Terrell Machine in Tx ,they they about $35 bucks, Terrell turns around and has them shipped from Datona Carburetor. Since i dont have a cleaning/soaking tank I call on a buddy to do that for me.Sort of round about but works

Geoff

coverton wrote:

I get them from Terrell Machine in Tx ,they they about $35 bucks, Terrell turns around and has them shipped from Datona Carburetor. Since i dont have a cleaning/soaking tank I call on a buddy to do that for me.Sort of round about but works

Walt informs me that it does have a 1-5/8" throat, so it is for a 1924 -'26 Hudson Super Six. I had a look at both Essex and Hudson carburettors on my shelf, and they both indicate "Model 25". Confusing! However, there is no way they would interchange. The "Series" is obviously the production number. I have Essex Carburettors with both series B and F on them. Even more confusing!

Geoff.