'35 kingpin ball bearings
Comments
-
.026 off the top of my head0
-
That's really tiny! Parts book says 1/4", 10 of them required.
Geoff0 -
Thanks guys. I thought probably 1/4", the end of a 1/4" drill bit fits the groove well, but its good to get official confirmation.0
-
i was off a decimal point, my bad0
-
FYI I can sell you a complete set with pins/bushings etc.0
This discussion has been closed.
Categories
- 36.9K All Categories
- 112 Hudson 1916 - 1929
- 20 Upcoming Events
- 92 Essex Super 6
- 28.6K HUDSON
- 571 "How To" - Skills, mechanical and other wise
- 995 Street Rods
- 151 American Motors
- 178 The Flathead Forum
- 49 Manuals, etc,.
- 78 Hudson 8
- 44 FORUM - Instructions and Tips on using the forum
- 2.8K CLASSIFIEDS
- 608 Vehicles
- 2.1K Parts & Pieces
- 77 Literature & Memorabilia
- Hudson 1916 - 1929 Yahoo Groups Archived Photos