1951 dodge engine Id
Mark
Member
How do I find out what is the cid of this engine
0
Comments
-
engine is not original 25 inches long0
-
The long blocks were either 251 or 265 cu in. . The p15-d24 board is devoted to mopar. Lots of info. over there. Hope this helps. LHud0
-
Mark, Not sure you're at the right place. You're looking for the engine ID to a 51 Dodge? OK well this is the Hudson forum. Likely not going to be of much help. Maybe the Mopar forum might be better for you. If you still think you have a Hudson engine then take a picture of it and post it.0
-
The Flathead Forum is a left-over from the days when this was the Classiccar Forum, and had categories for many different marques. So I think it's not unusual that we'd have someone occasionally posting about a Ford, Dodge, or whatever, under this particular category.
0 -
0
This discussion has been closed.
Categories
- 36.6K All Categories
- 86 Hudson 1916 - 1929
- 11 Upcoming Events
- 74 Essex Super 6
- 28.4K HUDSON
- 512 "How To" - Skills, mechanical and other wise
- 990 Street Rods
- 150 American Motors
- 170 The Flathead Forum
- 47 Manuals, etc,.
- 72 Hudson 8
- 40 FORUM - Instructions and Tips on using the forum
- 2.7K CLASSIFIEDS
- 592 Vehicles
- 2.1K Parts & Pieces
- 76 Literature & Memorabilia
- Hudson 1916 - 1929 Yahoo Groups Archived Photos